Audit trail
Audit trail
Well I have been up for a month or so, for some reason the audit trail is not showing, like the IP's of the callers. I went back in a double checked it was set to yes. WG 2.0 Dos. Great for denying them #*#*#*#*#'s. Thanks
-
daniel_spain
- Posts: 428
- Joined: Sun Aug 09, 2020 2:39 am
Re: Audit trail
Montroze wrote:
> Well I have been up for a month or so, for some reason the audit trail is
> not showing, like the IP's of the callers. I went back in a double checked
> it was set to yes. WG 2.0 Dos. Great for denying them #*#*#*#*#'s. Thanks
what tcp stack you using? by default wg 2.0 did not show ip info but major tcp/ip and
ico 2.0 did. so could be a setting within there config that is toggled off.
if memory serves me right and it has been years since i setup a 2.0 server,
both are in level 4 under "display incoming ip addresses to the audit trail"
also you can make use of whitelists to prevent ranges of ips from connecting.
> Well I have been up for a month or so, for some reason the audit trail is
> not showing, like the IP's of the callers. I went back in a double checked
> it was set to yes. WG 2.0 Dos. Great for denying them #*#*#*#*#'s. Thanks
what tcp stack you using? by default wg 2.0 did not show ip info but major tcp/ip and
ico 2.0 did. so could be a setting within there config that is toggled off.
if memory serves me right and it has been years since i setup a 2.0 server,
both are in level 4 under "display incoming ip addresses to the audit trail"
also you can make use of whitelists to prevent ranges of ips from connecting.