Page 1 of 1

Audit trail

Posted: Sun Apr 02, 2023 1:16 am
by Montroze
Well I have been up for a month or so, for some reason the audit trail is not showing, like the IP's of the callers. I went back in a double checked it was set to yes. WG 2.0 Dos. Great for denying them #*#*#*#*#'s. Thanks

Re: Audit trail

Posted: Mon Apr 10, 2023 7:32 pm
by daniel_spain
Montroze wrote:
> Well I have been up for a month or so, for some reason the audit trail is
> not showing, like the IP's of the callers. I went back in a double checked
> it was set to yes. WG 2.0 Dos. Great for denying them #*#*#*#*#'s. Thanks

what tcp stack you using? by default wg 2.0 did not show ip info but major tcp/ip and
ico 2.0 did. so could be a setting within there config that is toggled off.

if memory serves me right and it has been years since i setup a 2.0 server,
both are in level 4 under "display incoming ip addresses to the audit trail"

also you can make use of whitelists to prevent ranges of ips from connecting.